Supported Third-Party Hardware; J Series Compactflash And Memory Requirements - Juniper JUNOS OS 10.4 - RELEASE NOTES REV 6 Release Note

JUNOS OS 10.4 Release Notes
USB Modem
Storage Devices
190
You can also use CLI commands to choose which PIMs are disabled. For details about
calculating the power and heat dissipation capacity of each PIM and troubleshooting
procedures, see the J Series Services Routers Hardware Guide.

Supported Third-Party Hardware

The following third-party hardware is supported for use with J Series Services Routers
running Junos OS.
We recommend using a U.S. Robotics USB 56K V.92 Modem, model number USR 5637.
The USB slots on J Series Services Routers accept a USB storage device or USB storage
device adapter with a CompactFlash card installed, as defined in the CompactFlash
Specification published by the CompactFlash Association. When the USB device is
installed and configured, it automatically acts as a secondary boot device if the primary
CompactFlash card fails on startup. Depending on the size of the USB storage device,
you can also configure it to receive any core files generated during a router failure. The
USB device must have a storage capacity of at least 256 MB.
Table 17 on page 190 lists the USB and CompactFlash card devices supported for use with
the J Series Services Routers.
Table 17: Supported Storage Devices on the J Series Services Routers
Manufacturer
SanDisk—Cruzer Mini 2.0
SanDisk
SanDisk
Kingston
Kingston
SanDisk—ImageMate USB 2.0
Reader/Writer for CompactFlash Type I
and II
SanDisk CompactFlash
SanDisk CompactFlash

J Series CompactFlash and Memory Requirements

Table 18 on page 191 lists the CompactFlash card and DRAM requirements for J Series
Services Routers.
Storage Capacity Third-Party Part Number
256 MB SDCZ2-256-A10
512 MB SDCZ3-512-A10
1024 MB SDCZ7-1024-A10
512 MB DTI/512KR
1024 MB DTI/1GBKR
N/A SDDR-91-A15
512 MB SDCFB-512-455
1 GB SDCFB-1000.A10
Copyright © 2011, Juniper Networks, Inc.