Resolved Issues In Junos Os Release 10.4 For Srx Series Services Gateways And J Series Services Routers - Juniper JUNOS OS 10.4 - RELEASE NOTES REV 6 Release Note

Copyright © 2011, Juniper Networks, Inc.
Issues in Junos OS Release 10.4 for SRX Series Services Gateways and J Series Services Routers
VPNs
On SRX210 and SRX240 devices, concurrent login to the device from different
management systems (for example, laptop or desktop computers) is not supported.
The first user session is diconnected when a second user session is started from a
different management system. Also, the status for the first user system is displayed
incorrectly as Connected. [PR/434447]
On SRX Series and J Series devices, the site-to-site policy-based VPNs in a 3 or more
zone scenario will not work if the policies match the address "any" instead of specific
addresses, and all cross-zone traffic policies point to the single site-to-site VPN tunnel.
As a workaround, configure address books in different zones to match the source and
destination, and use the address book name in the policy to match the source and
destination. [PR/441967]
On SRX100, SRX210, SRX240, and SRX650 devices, Routing Engine level redundancy
for dynamic VPN fails because the tunnels need to renegotiate after RG0 failover.
[PR/513884]
On SRX100, SRX210, SRX240, and SRX650 devices, the dynamic VPN server always
pushes the last configured dynamic client configuration to the client. If the VPN
configuration bound to this dynamic VPN client is not bound to a policy, IKE negotiation
fails when you try to connect to the server. [PR/514033]
On SRX100, SRX210, SRX240, and SRX650 devices, the dynamic VPN client is not
downloaded if there is not enough space in the /jail/var directory in the dynamic VPN
server. [PR/515261]
On SRX3400 and SRX3600 devices, the VPN monitor status in the DEP server side
stays down for some time after RG0 and RG1 failover because there is no active state
sync up for VPN monitoring. [PR/532952]
WLAN
On SRX210, SRX240, and SRX650 devices, J-Web online Help displays the list of all
the countries and is not based on the regulatory domain within which the access point
is deployed. [PR/469941]
WXC Integrated Services Module
When two J Series devices with WXC Integrated Services Modules (WXC ISM 200s)
installed are configured as peers, traceroute fails if
peers. [PR/227958]
On J6350 devices, Junos OS does not support policy-based VPN with WXC Integrated
Services Modules (WXC ISM 200s). [PR/281822]
Resolved Issues in Junos OS Release 10.4 for SRX Series Services Gateways and
J Series Services Routers
The following are the issues that have been resolved since Junos OS Release 10.4R1 for
Juniper Networks SRX Series Services Gateways and J Series Services Routers. The
identifier following the descriptions is the tracking number in the Juniper Networks Problem
Report (PR) tracking system.
is configured on both
redirect-wx
175