Juniper JUNOS OS 10.4 - RELEASE NOTES REV 6 Release Note page 187

Errata and Changes in Documentation for Junos OS Release 10.4 for SRX Series Services Gateways and J Series Services Routers
Copyright © 2011, Juniper Networks, Inc.
Fan tray LED table in the "Replacing the Fan Tray on the SRX1400 Services Gateway"
section of the SRX1400 Services Gateway Hardware Guide erroneously documents
that:
The Amber (On Steadily): Fan tray LED cannot detect fan failure.
The correct information for this section is as follows: Amber LED (on steadily): Fan
tray LED does not indicate fan failure .
Some of the graphics in the SRX1400 Services Gateway Hardware Guide show the
grounding lug attached to the front panel of the device. However, the SRX1400 Services
Gateway is not shipped with grounding lug attached to it.
In the SRX1400 Services Gateway Hardware Guide, the following topics erroneously
document "RE ETHERNET" port as "ETHERNET" port.
Connecting the SRX1400 Services Gateway to a Network for Out-of-Band
Management
SRX1400 Services Gateway Software Configuration Overview
The SRX1400 Services Gateway Hardware Guide and the SRX1400 Services Gateway
Getting Started Guide are missing the following note:
NOTE: AC and DC power supply units are not interoperable between the
SRX1400 Services Gateway and the SRX3000 and SRX5000 lines.
SRX1400 Services Gateway Getting Started Guide
The SRX1400 Services Gateway Getting Started Guide includes information about the
following DC-powered SRX1400 Services Gateways:
SRX1400BASE-GE-DC
SRX1400BASE-XGE-DC
These models are not available in Junos OS Release 10.4. Contact your Juniper Networks
customer service representative for information on these models.
In the SRX1400 Services Gateway Getting Started Guide, some of the graphics are shown
with grounding lug attached on the front panel of the device. However, the SRX1400
Services Gateway is not shipped with grounding lug attached to it.
Some of the graphics in the SRX1400 Services Gateway Getting Started Guide show
graphics with the grounding lug attached to the device front panel. The grounding lug
is not attached to the device at the time of shipment.
The SRX1400 Services Gateway Getting Started Guide should document the following
statement:
You can replace the Network and Services Processing Card (NSPC) with the SRX3000
line Services Gateway Network Processing Card (NPC) and Services Processing Card
(SPC). To install the NPC and SPC on the SRX1400 Services Gateway, you must order
the Twin CFM holder tray (SRX1K3K-2CFM-TRAY) to hold two single-wide CFMs (NPC
187