Verifying The Configuration Of The Profiles Using The Cli; Verifying The Establishment Of The Fcip Tunnel Using The Cli - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Chapter 20 Troubleshooting IP Storage Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Mar 13 19:18:20
up tunnel
Mar 13 19:18:20
bring up again...

Verifying the Configuration of the Profiles Using the CLI

Use the show fcip profile command to verify that the configuration of the profiles are correct. The IP
address and TCP port are the ports to listen on, and both are adjustable in the FCIP profile. Thefollowing
example displays all the default values that are adjustable while configuring the FCIP profile.
MDS1# show fcip profile
-------------------------------------------------------------------------------
ProfileId
-------------------------------------------------------------------------------
28
MDS1# show fcip profile 28
FCIP Profile 28

Verifying the Establishment of the FCIP Tunnel Using the CLI

Use the show interface fcip command to verify that the FCIP tunnel is established and that traffic is
passing through.
MDS1# show interface fcip 28
FCIP28 is trunking
(The FCIP tunnel will be either E (ISL or TE (EISL) passing through multiple VSANs.)
vsan is 1
(This is the FCIP profile and the Gigabit Ethernet being used by the FCIP tunnel.)
Peer Information
(This is the remote endpoint's IP address and listening port.)
Special Frame is disabled
(The special frame for verification of a remote MDS is not being used.)
Maximum number of TCPconnections is 2
(The default is 2 TCP connections being used, one for class F and the other for class 2 and 3.)
OL-9285-05
port8: 2718:FCIP28: Tunnel bringup debounce timer callbeck, try to bring
port8: 2719:FCIP28: Tunnel is already in oper UP state, don't try to
Ipaddr
10.10.10.2
Listen Port is 3225
TCP parameters
SACK is disabled
PMTU discover is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 100 ms
Maximum number of re-transmissions is 4
Advertised window size is 64 KB
Hardware is GigabitEthernet
Port WWN is 20:5e:00:05:30:00:59:de
Peer port WWN is 20:5e:00:0b:5f:d5:9f:c0
Admin port mode is auto, trunk mode is on
Port mode is TE
Trunk vsans (allowed active) (1-2)
Trunk vsans (operational)
Trunk vsans (up)
Trunk vsans (isolated)
Trunk vsans (initializing)
Using Profile id 28 (interface GigabitEthernet2/8)
Peer Internet address is 10.10.11.2 and port is 3225
Time Stamp is disabled
TcpPort
3225
(1-2)
(1-2)
()
()
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
FCIP Issues
20-15