Configuring Call Home Contact Information Using Fabric Manager; Configuring Call Home Contact Information Using The Cli - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Chapter 25 Troubleshooting Call Home
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring Call Home Contact Information Using Fabric Manager

To assign the contact information, follow these steps:
Step 1 Choose Switches > Events > Call Home in the Physical Attributes pane.
Click the General tab and then assign contact information. You must enter an e-mail address that
Step 2
identifies the source of Call Home notifications.
Step 3 Click Apply Changes.

Configuring Call Home Contact Information Using the CLI

To assign the contact information, follow these steps:
Command
Step 1
switch# config t
Step 2
switch# snmp-server contact
personname@companyname.com
Step 3
switch(config)# callhome
switch(config-callhome)#
Step 4
switch(config-callhome)# email-contact
username@company.com
OL-9285-05
Purpose
Enters configuration mode.
Configures the SNMP contact name.
Enters the Call Home configuration submode.
Assigns the customer's e-mail address. Up to 128
alphanumeric characters are accepted in e-mail
address format.
Note You can use any valid e-mail address.
You cannot use spaces.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
Call Home Issues
25-7