Recovering A Replacement Ssm - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

SSM Issues
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
kickstart variable = bootflash:/boot-2-0-1-9
system variable =
bootflash:/isan-2-0-1-9;bootflash:/isan-2-0-0-181b;bootflash:/isan-2-0-0-181b
sup-2
kickstart variable = bootflash:/boot-2-0-1-9
system variable =
bootflash:/isan-2-0-1-9;bootflash:/isan-2-0-0-181b;bootflash:/isan-2-0-0-181b
Module 4
ssi variable = modflash://4-1/m9000-ek9-ssi-mz.2.1.2.bin
Save the new boot variable configuration so that the new boot image is used when the switch reboots.
Step 8
switch# copy running-config startup-config
Note
Step 9 Issue the show module command to verify the status of the SSM.
switch# show module
Mod
---
4
5
6
Mod
---
4
5
6
Mod
-------- -----------------------------
4
Mod
---
4
5
6
* this terminal session

Recovering a Replacement SSM

In Cisco MDS SAN-OS Release 2.1(2) and later, you use the CompactFlash memory (modflash:) on the
SSM to store the SSI image. If the SSM is replaced, the new SSM might not initialize.
To recover the SSM, follow these steps:
Log in to the switch through the console port, an SSH session, or a Telnet session.
Step 1
Display the values assigned to the SSI image boot variable for each module and note the values for later
Step 2
reference.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
3-8
If you do not save this configuration, it is lost when the switch reboots. In addition, SSM restarts
in Fibre Channel switching mode. You must perform this procedure again to recover the SSI boot
image configuration.
Ports Module-Type
----- -------------------------------- ------------------ ------------
32 Storage Services Module
0 Supervisor/Fabric-1
0 Supervisor/Fabric-1
Sw Hw World-Wide-Name(s) (WWN)
----------- ------ --------------------------------------------------
2.1(2) 0.30 20:c1:00:05:30:00:06:de to 20:e0:00:05:30:00:06:de
2.1(2) 4.0 --
2.1(2) 4.0 --
Application Image Description
SSI linecard image
MAC-Address(es)
--------------------------------------
00-05-30-00-9e-b2 to 00-05-30-00-9e-b6
00-0e-38-c6-2c-6c to 00-0e-38-c6-2c-70
00-0f-34-94-4d-34 to 00-0f-34-94-4d-38
Chapter 3 Managing Storage Services Modules
Model Status
DS-X9032-SSM ok
DS-X9530-SF1-K9 active *
DS-X9530-SF1-K9 ha-standby
Application Image Version
-------------------------
2.1(2)
Serial-Num
----------
JAB06480590
JAB082504MQ
JAB083407D3
OL-9285-05