Verifying Interfaces Configuration; Displaying Interface Information - Cisco MDS 9000 Series Configuration Manual

Configuring Interfaces

Verifying Interfaces Configuration

Displaying Interface Information

Run the show interface command from user EXEC mode. This command displays the interface configurations.
Without any arguments, this command displays the information for all the configured interfaces in the switch.
The following example displays the status of interfaces:
Displays All Interfaces
switch# show interface
fc1/1 is up
.
.
.
fc3/8 is trunking
Hardware is Fibre Channel, SFP is short wave laser w/o OFC (SN)
Port WWN is 20:01:54:7f:ee:de:c5:00
Admin port mode is SD
snmp link state traps are enabled
Port mode is SD
Port vsan is 1
Admin Speed is 8 Gbps
Operating Speed is 8 Gbps
Rate mode is dedicated
Beacon is turned off
Logical type is Unknown(0)
5 minutes input rate 0 bits/sec,0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec,0 bytes/sec, 0 frames/sec
4 frames input,304 bytes
0 discards,0 errors
0 invalid CRC/FCS,0 unknown class
0 too long,0 too short
4 frames output,304 bytes
0 discards,0 errors
0 input OLS,0 LRR,0 NOS,0 loop inits
0 output OLS,0 LRR, 0 NOS, 0 loop inits
1 receive B2B credit remaining
0 transmit B2B credit remaining
0 low priority transmit B2B credit remaining
Interface last changed at Mon Apr 24 23:10:49 2017
Last clearing of "show interface" counters :
Hardware is Fibre Channel, SFP is short wave laser w/o OFC (SN)
Port WWN is 20:88:54:7f:ee:de:c5:00
Admin port mode is auto, trunk mode is on
snmp link state traps are enabled
Port mode is TF
Port vsan is 1
Admin Speed is auto max 32 Gbps
Operating Speed is 16 Gbps
Rate mode is dedicated
Port flow-control is R_RDY
Transmit B2B Credit is 64
Receive B2B Credit is 32
never
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
Verifying Interfaces Configuration
61