Reinitializing A Failed Module Using The Cli - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Chapter 4 Troubleshooting Hardware
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switch# reload module 2 force-dnld
If the module is still not up, choose Switches > Hardware and view the Power Admin column to verify
Step 6
the power status for the module.
Step 7 If the module is not powered on, remove and reseat the module and select on from the Power Admin
drop-down menu to power on the module.
Step 8 If the module is still not operating, right-click on the switch in the map pane and select Reset to reload
the entire switch.

Reinitializing a Failed Module Using the CLI

To reinitialize a failed module using the CLI, follow these steps:
Save the running configuration to the startup configuration.
Step 1
switch# copy running-config start-config
Reload the module.
Step 2
switch# reload module 2
If the module is not operating, verify the software image on the module.
Step 3
switch# show module
If the software image on the module is not the latest, download the latest image to supervisor bootflash
Step 4
memory.
switch# copy tftp: bootflash:
Force-download the software image from the supervisor to the module.
Step 5
switch# reload module 2 force-dnld
If the module is still not operating, verify the power status for the module.
Step 6
switch# show environment power
If the module is not powered on, remove and reseat the module and then power on the module.
Step 7
switch# config t
switch(config)# no poweroff module 2
switch(config)# exit
switch#
If the module is still not operating, reload the entire switch.
Step 8
switch# reload
OL-9285-05
Troubleshooting Switching and Services Modules
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
4-37