Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual page 269

Chapter 13 Troubleshooting IVR
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
activation failed in VSAN [dec].
Error Message IVR-5-IVZS_ACTIVATION_RETRYING: Inter-VSAN zoneset activation failed
with error [hex] in VSAN [dec]. retrying after [dec] seconds.
Error Message IVR-5-IVZS_WAITING_FOR_LOWEST_SWWN: Waiting for lowest switch WWN
Inter-VSAN enabled switch in VSAN [dec].
Symptom
Table 13-6 IVR Activation Fails
Symptom Possible Cause
IVR zone set Overlapping domain IDs.
activation fails.
Default zone policy is permit.
Default zone policy is deny and no
active zone set present.
No active zone set.
OL-9285-05
IVR-3-IVZ_ACTIVATION_FAILED_VSAN: Inter-VSAN zoneset [chars]
Explanation Inter-VSAN zone set activation failed in the VSAN.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Inter-VSAN zone set activation failed with VSAN shown in the error message. This
Explanation
could be an intermittent regular zone set activation error. The activation retried in the number of
seconds shown in the error message.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.3(3).
Introduced
This switch does not have the lowest switch world wide name (sWWN) in the VSAN.
Explanation
Only the inter-VSAN (IVR) enabled switch with the lowest sWWN can add the IVR zones to the
regular active zone set in a VSAN. This switch is waiting until the IVR switch with the lowest
sWWN adds the IVR zone and reactivates the zone set.
Recommended Action No action is required.
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
IVR zone set activation fails.
Solution
Use static domain IDs to assign unique domain IDs to each
switch in the VSAN or use IVR NAT. Choose Fabricxx >
All VSANs > Domain Manager in Fabric Manager or use
the fcdomain domain domain-id [static | preferred] vsan
vsan-id CLI command
Choose Zone > IVR > Edit Local Full Zone Database in
Fabric Manager. Right-click the IVR zone set that you want
to activate and select Activate. Check the Create Active
Zone Set if none Present check box or use the force option
with the ivr zoneset activate CLI command.
No zone set has been activated. See the
Zone Set Activation" section on page 14-8
zone set on an IVR-enabled switch, or use the force option
when activating the IVR zone set.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
IVR Issues
"Troubleshooting
to activate a
13-9