Verifying The Vtp Configuration On A Set/Clear Cli; Displaying Vtp Statistics - Cisco RJ-45-to-AUX Brochure

1900EN(config)#vtp domain Coriolis
1900EN(config)#
To set a VTP domain password on a 1900EN to "pass1" use the following command:
1900EN(config)# vtp password pass1
1900EN(config)#

Verifying the VTP Configuration on a Set/Clear CLI

To verify the VTP domain information, use the command show vtp domain. This command will show you
the domain name, mode, and pruning information:
5002> (enable) show vtp domain
Domain Name
———————————————
Coriolis
Vlan−count Max−vlan−storage Config
—————————— ———————————————— ——————————————— ——————————————
2 1023
Last Updater V2 Mode Pruning
———————————— ———————— ———————
130.10.10.14 enabled disabled 2−1000
Console> (enable)
Warning You cannot use the show vtp domain command on a 1900. You should use the show vtp
statistics command instead.

Displaying VTP Statistics

The show vtp statistics command shows a summary of the VTP advertisement messages that have been sent
and received, as well as errors. The command is the same on the Set/Clear and Cisco CLI switches.
5002> (enable) show vtp statistics
VTP statistics:
summary advts received
subset advts received
request advts received
summary advts transmitted
subset advts transmitted
request advts transmitted
No of config revision errors
No of config digest errors
VTP pruning statistics:
Trunk Join Transmitted Join Received Summary advts received from
——————— ———————————————— ————————————— ——————————————————————————
2/12 0
5000> (enable)
1912EN#sh vtp stat
Receive Statistics
———————————————————————————— —————————————————————————————
Summary Adverts
Subset Adverts
Advert Requests
Configuration Errors:
Revision Errors
Domain Index VTP Version Local Mode
———————————— ————————— ————————
1 2
Revision Notifications
1
PruneEligible on Vlans
———————————————————————
0
0
0
5
2
0
0
0
0
0 Summary Adverts
0 Subset Adverts
0 Advert Requests
0
—————————
server
disabled
non−pruning−capable device
0
Transmit Statistics
0
0
56
111
Password
−