Verification Of Static Ip Routing; Verifying Static Ip Routing Using Device Manager; Verifying Static Ip Routing Using The Cli - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

IP Issues
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Use the fcping command to verify reachability to the destination switch.
Step 3
switch# fcping fcid 0xFFFCDA vsan 200
28 bytes from 0xFFFCDA time = 298 usec
28 bytes from 0xFFFCDA time = 260 usec
28 bytes from 0xFFFCDA time = 298 usec
28 bytes from 0xFFFCDA time = 294 usec
28 bytes from 0xFFFCDA time = 292 usec
5 frames sent, 5 frames received, 0 timeouts
Round-trip min/avg/max = 260/288/298 usec

Verification of Static IP Routing

Use the procedures in this section to verify static IP routing.

Verifying Static IP Routing Using Device Manager

Choose IP > Routes in Device Manager to verify the static IP routes.

Verifying Static IP Routing Using the CLI

To verify static IP routes using the CLI, follow these steps:
Step 1 Use the show ip route config or the show ipv6 route command to verify the routes configured.
switch# show ip route config
Use the show ip route or the show ipv6 route command to verify that the IP routes are still present.
Step 2
switch# show ip route
Codes: C - connected, S - static
Default gateway is 172.17.8.1
C 172.17.8.0/24 is directly connected, mgmt0
S 11.2.36.0/22 via 11.3.36.1, gigabitethernet8/7
C 11.3.36.0/22 is directly connected, gigabitethernet8/7
C 11.3.56.0/22 is directly connected, gigabitethernet8/8
S 11.2.56.0/22 via 11.3.56.1, gigabitethernet8/8
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
20-8
Destination Gateway
default 172.17.8.1
11.2.36.0 11.3.36.1
11.2.56.0 11.3.56.1
11.3.36.0 0.0.0.0
11.3.56.0 0.0.0.0
172.17.8.0 0.0.0.0
Chapter 20
Mask Metric
0.0.0.0 0
255.255.252.0 0
255.255.252.0 0
255.255.252.0 0 GigabitEthernet8/7
255.255.252.0 0 GigabitEthernet8/8
255.255.255.0 0
Troubleshooting IP Storage Services
Interface
mgmt0
mgmt0
OL-9285-05