Displaying The Debug Output From The Second Switch Using The Cli - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

FCIP Issues
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
MDS1# show fcip profile 21
FCIP Profile 21

Displaying the Debug Output from the Second Switch Using the CLI

The following debug output is from switch MDS2.
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
(The switch is attempting to create a TCP connection on port 13. The creation port must match the TCP
listen port on the remote endpoint.)
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
Mar 14 23:26:07
MDS2(config-if)# peer-info ipaddr 10.10.10.2 port 3225
(This changes the start active connection port to match the default port 3225.)
Or you can use this command:
MDS2(config-if)# no peer-info ipaddr 10.10.10.2 port 13
(Removing port 13 will also set it to the default of 3225.)
MDS2# show interface fcip 21
fcip21 is trunking
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
20-26
Using Profile id 21 (interface GigabitEthernet2/1)
Peer Information
Peer Internet address is 10.10.10.2 and port is 13
Internet Address is 10.10.10.2
Listen Port is 3225
TCP parameters
SACK is disabled
PMTU discover is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 300 ms
Maximum number of re-transmissions is 4
Advertised window size is 64 KB
port1: 1340:FCIP21: Start TCP listener with peer: 10.10.10.2:3225
port1: 1341:FCIP: Create a new listener object for 10.10.11.2:3225
port1: 1342:FCIP: Create FCIP Listener with local info: 10.10.11.2:3225
port1: 1343:FCIP21: Create a DE 0xd802d140 for this tunnel
port1: 1344:FCIP21: Bind the DE 0xd802d140 [1] to tunnel LEP 0x80111570
port1: 1345:FCIP21: Start the active connection [1] to 10.10.10.2:13
port1: 1346:FCIP21: Create a DE 0xd802cdc0 for this tunnel
port1: 1347:FCIP21: Bind the DE 0xd802cdc0 [2] to tunnel LEP 0x80111570
port1: 1348:FCIP21: Start the active connection [2] to 10.10.10.2:13
port1: 1349:FCIP21: Active Connect creation FAILED [1]
port1: 1350:FCIP21: Delete the DE [1]0xd802d140
port1: 1351:FCIP21: Delete the DE object [1] 0xd802d140
port1: 1352:FCIP21: Try 7 to bring up the tunnel
port1: 1353:FCIP21: Start the bringup tunnel timer, timeout: 64000
port1: 1354:FCIP21: Active Connect creation FAILED [2]
port1: 1355:FCIP21: Delete the DE [2]0xd802cdc0
port1: 1356:FCIP21: Set lep operation state to DOWN
port1: 1357:FCIP21: Delete the DE object [2] 0xd802cdc0
port1: 1358:FCIP21: Try 8 to bring up the tunnel
port1: 1359:FCIP21: Start the bringup tunnel timer, timeout: 128000
Hardware is GigabitEthernet
Port WWN is 20:42:00:0b:5f:d5:9f:c0
Peer port WWN is 20:42:00:05:30:00:59:de
Admin port mode is auto, trunk mode is on
Port mode is TE
vsan is 1
Trunk vsans (allowed active) (1-2)
Trunk vsans (operational)
Chapter 20
(interface GigabitEthernet2/1)
(1-2)
Troubleshooting IP Storage Services
OL-9285-05