Chapter 8 Troubleshooting Ports; Overview; Initial Troubleshooting Checklist - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Troubleshooting Ports
This chapter describes how to identify and resolve problems that can occur with ports in the Cisco MDS
9000 Family of multilayer directors and fabric switches. It includes the following sections:
•
•
•
•

Overview

Before a switch can relay frames from one data link to another, the characteristics of the interfaces
through which the frames are received and sent must be defined. The configured interfaces can be Fibre
Channel interfaces, Gigabit Ethernet interfaces, the management interface (mgmt0), or VSAN interfaces
(IPFC).
Each physical Fibre Channel interface in a switch can operate in one of several port modes: E port, F
port, FL port, TL port, TE port, SD port, and B port. In addition to these modes, each interface can be
configured in auto or Fx port modes. These modes determine the port type during interface initialization.
Each interface has an associated administrative configuration and operational status:
•
•
For a complete description of port modes, administrative states, and operational states, refer to the Cisco
MDS 9000 Family Configuration Guide and the Cisco MDS 9000 Fabric Manager Configuration Guide.

Initial Troubleshooting Checklist

Troubleshooting a SAN problem involves gathering information about the configuration and
connectivity of individual devices and the entire SAN fabric. In the case of port interfaces, begin your
troubleshooting activity as follows:
OL-9285-05
Overview, page 8-1
Initial Troubleshooting Checklist, page 8-1
Overview of the FC-MAC Driver and the Port Manager, page 8-4
Common Problems with Port Interfaces, page 8-13
The administrative configuration does not change unless you modify it. This configuration has
various attributes that you can configure in administrative mode.
The operational status represents the current status of a specified attribute like the interface speed.
This status cannot be changed and is read-only. Some values may not be valid when the interface is
down (such as the operation speed).
C H A P T E R
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
8
8-1