Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual page 66

Troubleshooting Cisco SAN-OS Software System Reboots
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
You see the configured changes. (See
Figure 2-6
Press the Esc key to return to the main menu.
Step 12
Choose Write to CMOS and Exit from the main screen to save your changes.
Step 13
Note
Caution
You see the following prompt:
switch(boot)#
Enter the init system command at the
Step 14
system.
switch(boot)# init system
Note
Caution
Follow the procedure specified in the
Step 15
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
2-18
BIOS Setup Configuration (CMOS) Changes
These changes are saved in the CMOS.
The switch must have IP connectivity to reboot using the newly configured values.
The init system command also installs a new loader from the existing (running) kickstart image.
Be sure that you have made a backup of the configuration files before you issue this command.
Chapter 2 Troubleshooting Installs, Upgrades, and Reboots
Figure 2-6.)
prompt, and press Enter to reformat the file
switch(boot)#
"Recovery from the switch(boot)# Prompt" section on page 2-21.
OL-9285-05