Verifying Fabric Binding Violations Using The Cli - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

Chapter 19 Troubleshooting FC-SP, Port Security, and Fabric Binding
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Optionally follow these steps to add the switch to the fabric binding database:
Step 3
a.
b.
c.
d.
e.

Verifying Fabric Binding Violations Using the CLI

To verify fabric binding violations using the CLI, follow these steps:
Use the show port-security violations command and search for the interface that is shut down.
Step 1
switch# show fabric-binding violations
-------------------------------------------------------------------------------
VSAN Switch WWN [domain] Last-Time [Repeat count] Reason
-------------------------------------------------------------------------------
2 20:00:00:05:30:00:4a:1e [*] Nov 25 05:44:58 2003 [2] sWWN not found
3 20:00:00:05:30:00:4a:1e [0xeb] Nov 25 05:46:14 2003 [2] Domain mismatch
4 20:00:00:05:30:00:4a:1e [*] Nov 25 05:46:25 2003 [1] Database mismatch
In VSAN 2, the sWWN itself was not found in the list. In VSAN 3, the sWWN was found in the list, but
has a domain ID mismatch.
Optionally, remove the switch and use the no shutdown command to bring the ISL back online.
Step 2
Optionally follow these steps to add the switch to the fabric binding database:
Step 3
a.
b.
c.
d.
OL-9285-05
Choose Fabricxx > VSANxx > Fabric Binding and select the Actions tab.
Check the CopyActive to Config check box and click Apply Changes to copy the active database
to the configure database. This ensures that no learned entries are lost.
Select the Config Database tab and click Add Row to add a new entry into the configure database.
Fill in the WWNs and Domain ID fields and click Create.
Select the Actions tab, select activate from the Action drop-down menu, and click Apply Changes
to copy the configure database to the active database and reactivate fabric binding.
Use the fabric-binding database copy command to copy the active database to the configure
database.
switch# fabric-binding database copy vsan 3
Use the fabric-binding database command to add a new entry into the configure database.
switch(config)# fabric-binding database vsan 3
switch(config-fabric-binding)# swwn 20:11:33:11:00:2a:4a:66
Use the fabric-binding activate command to copy the configure database to the active database and
reactivate fabric binding.
switch(config)# fabric-binding activate vsan 3
Use the no shutdown command in interface mode to bring the port back online.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
Fabric Binding Issues
19-17