Islb Issues; Islb Configuration Not Distributed To All Switches In The Fabric - Cisco 9134 - MDS Multilayer Fabric Switch Troubleshooting Manual

iSLB Issues

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
iSLB Issues
This section describes common troubleshooting issues for iSLB and includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

iSLB Configuration Not Distributed to All Switches in the Fabric

Symptom
Table 20-1 iSLB Configuration Not Distributed to All Switches in the Fabric
Symptom Possible Cause
iSLB configuration Not all switches are running Cisco
not distributed to all SAN-OS Release 3.0(1) or later.
switches in the fabric.
CFS distribution is not enabled for
iSLB.
Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x
20-58
iSLB Configuration Not Distributed to All Switches in the Fabric, page 20-58
iSCSI Initiator and Virtual Target Configuration Not Distributed, page 20-59
iSLB Configuration, Commit, or Merge Failed—"VSAN ID is Not Yet Configured", page 20-59
iSLB Configuration, Commit, or Merge Failed—"Failed to Allocate WWN", page 20-60
iSLB Configuration, Commit, or Merge Failed—"Duplicate WWN Found as...", page 20-60
iSLB Configuration, Commit, or Merge Failed—"Duplicate Node Name", page 20-60
iSLB Configuration Failed—"Pending iSLB CFS Config Has Reached Its Limit...", page 20-61
iSCSI Disable Failed—"Cannot Disable Iscsi - Large Iscsi Config Present...", page 20-61
iSLB Commit Timeout, page 20-61
Session Down—"pWWN in Use At Remote Switch", page 20-62
Redirected Session Does Not Come Up, page 20-62
iSLB Zones Not Present in Active Zone Set, page 20-63
Traffic Description After iSLB Commit or Activation of Zone Set, page 20-63
VRRP Master Overutilized, page 20-64
iSLB Zone Set Activation Failed, page 20-64
iSLB CFS Commit Fails, page 20-65
Resolving an iSLB Merge Failure, page 20-65
iSLB configuration is not distributed to all switches in the fabric.
Chapter 20
Solution
Update switches to Cisco SAN-OS Release 3.0(1) or later.
Enable CFS distribution for iSLB. Use the show cfs
application name islb CLI command to determine if CFS
distribution is enabled. Or use the show cfs peers name
islb CLI command and check to see if any switches are
missing from the output.
Use the islb distribute CLI command to enable CFS
distribution.
Troubleshooting IP Storage Services
OL-9285-05