Set Enclosure Attribute - Dell PowerVault MD3000i Cli Manual

Parameter
owner
availability
NOTE:
When using this command, you can specify one or more of the parameters.
You do not, however, need to use all of the parameters.
NOTE:
Setting addPhysicalDisks or raidLevel starts a long operation that cannot be
stopped.

Set Enclosure Attribute

This command sets user-defined attributes for an enclosure.
Syntax
set enclosure [ enclosureID ] (chassisName |
assetTag)= " userID "
Parameters
Parameter
enclosure
chassisName
170
Script Commands
Description
RAID controller module that owns the disk group. Valid RAID
controller module identifiers are 0 or 1, where 0 is the RAID
controller module on the left and 1 is the RAID controller module
on the right when viewed from the rear of the enclosure.
Sets the disk group online or offline.
Description
Identifies a specific enclosure for which to set the attribute.
Enclosure ID values are 0 to 99. You must put brackets ([ ])
around the enclosure ID value.
Chassis name or number to give the new enclosure. Chassis names
can be any combination of alphanumeric characters with a
maximum length of 32 characters. Alphabetical characters can be
uppercase or lowercase. You can also use the underscore character
(_) and the hyphen (-) character. You cannot use spaces in a chassis
name. You must put quotation marks (" ") around the chassis
name.