Save RAID Controller Module NVSRAM
This command saves a copy of the RAID controller module NVSRAM values
to a file. This command saves all regions.
Syntax
save controller [(0 | 1)] NVSRAM file=" filename "
Parameters
Parameter
controller
file
Save Storage Array Configuration
This command creates a script file to use to create the current storage array
virtual disk configuration.
Syntax
save storageArray configuration file=" filename "
[(allConfig | globalSettings=(TRUE | FALSE)
virtualDiskConfigAndSettings=(TRUE | FALSE)
hostTopology=(TRUE | FALSE)
lunMappings=(TRUE | FALSE))]
Parameters
Parameter
file
162
Script Commands
Description
RAID controller module with the NVSRAM values to save.
Valid RAID controller module identifiers are 0 or 1, where 0
is the RAID controller module on the left and 1 is the RAID
controller module on the right when viewed from the rear of
the enclosure. You must put brackets ([ ]) around the RAID
controller module identifier.
Name of the file in which to save the values. You must put
quotation marks (" ") around the file name.
Description
Name of the file that contains the configuration values.
You must put quotation marks (" ") around the file
name.