Reset Storage Array Battery Install Date; Reset Storage Array Iscsi Baseline - Dell PowerVault MD3000i Cli Manual

Parameters
Parameter
controller

Reset Storage Array Battery Install Date

This command resets the age of the batteries in a storage array to zero days.
You can reset the batteries for an entire storage array or the battery in a
specific RAID controller module.
Syntax
reset storageArray batteryInstallDate controller=
(0 | 1)
Parameters
Parameter
controller
NOTE:
If you do not specify a RAID controller module, the age is reset for the
storage array battery or both RAID controller module batteries. If you specify a
RAID controller module, then the age for only that RAID controller module battery is
reset.

Reset Storage Array iSCSI Baseline

This command resets the iSCI baseline for the storage array to 0.
Syntax
reset storageArray iscsiStatsBaseline
158
Script Commands
Description
RAID controller module to reset. Valid RAID controller
module identifiers are 0 or 1, where 0 is the RAID controller
module on the left and 1 is the RAID controller module on
the right when viewed from the rear of the enclosure. You
must put brackets ([ ]) around the RAID controller module
identifier. If you do not specify an owner, the RAID controller
module firmware returns a syntax error.
Description
Specifies the RAID controller module that contains the
battery for which to reset the age. Valid RAID controller
module identifiers are 0 or 1, where 0 is the controller in
slot 0, and 1 is the controller in slot 1.