Re-Create Snapshot - Dell PowerVault MD3000i Cli Manual

Parameter
owner

Re-create Snapshot

This command starts a new copy-on-write operation by using an existing
snapshot virtual disk. You can re-create a single snapshot virtual disk or re-
create multiple virtual disks.
NOTE:
Refer to "Preparing Host Servers to Re-create a Snapshot Virtual Disk" on
page 75.
NOTICE:
Before you create a new point-in-time image of a source virtual disk, stop
any data access (I/O) activity or suspend data transfer to the source virtual disk to
ensure that you capture an accurate point-in-time image of the source virtual disk.
Close all applications, including Windows
activity has stopped.
NOTE:
Removing the drive letter of the associated virtual disk in Windows or
unmounting the virtual drive in Linux will help to guarantee a stable copy of the
drive for the Snapshot.
Syntax
recreate snapshot (virtualDisk [ virtualDiskName ] |
virtualDisks [ virtualDiskName1 ...
virtualDiskNamen ]) [userLabel=
" snapshotVirtualDiskName "
warningThresholdPercent= percentValue
repositoryFullPolicy=(failSourceWrites |
failSnapShot)]
Description
RAID controller module that owns the virtual disk. Valid
RAID controller module identifiers are 0 or 1, where 0 is
the RAID controller module on the left and 1 is the RAID
controller module on the right when viewed from the rear
of the enclosure. If you do not specify an owner, the RAID
controller module firmware determines the owner. For
information about the owner parameter, see "Creating
Virtual Disks with User-Assigned Physical Disks" on
.
page 48
®
Internet Explorer
Script Commands
®
, to make sure all I/O
153