Revive Disk Group; Revive Physical Disk - Dell PowerVault MD3000i Cli Manual

Command line interface guide
Hide thumbs Also See for PowerVault MD3000i:
Table of Contents

Advertisement

NOTICE:
or the virtual disk will not be accessible.
NOTE:
Under certain host operating system environments, you might be required to
reconfigure the multipath host physical disk. You might also need to make operating
system modifications to recognize the new I/O path to the virtual disks.

Revive Disk Group

This command forces the specified disk group and associated failed physical
disks to the Optimal state. All physical disks assigned to the disk group must
be installed before you attempt to run this command.
NOTICE:
the physical disks in the disk group. Never attempt to revive a physical disk unless
supervised by a Customer or Technical Support representative.
NOTICE:
Do not attempt to run this command o a disk group that is in the Degraded
state. Running this command on a disk group that is in the Degraded state can
cause loss of access to the data on the physical disks in the disk group.
Syntax
revive diskGroup [ diskGroupNumber ]
Parameters
Parameter
diskGroup

Revive Physical Disk

This command forces the specified physical disk to the Optimal state.
NOTICE:
physical disks in the disk group. Never attempt to revive a physical disk unless
supervised by a Technical Support representative.
Syntax
revive physicalDisk [ enclosureID,slotID ]
160
Script Commands
Ensure that the multipath driver is running before you use this command,
Correct use of this command depends on the data configuration on all of
Description
Number of the disk group to be set to the Optimal state. You
must put brackets ([ ]) around the disk group number.
Correct use of this command depends on the data configuration on all

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powervault modular disk storage manager

Table of Contents