Repair Virtual Disk Consistency; Reset Raid Controller Module - Dell PowerVault MD3000i Cli Manual

Repair Virtual Disk Consistency

This command repairs the consistency errors on a virtual disk.
Syntax
repair virtualDisk [ virtualDiskName ] consistency
consistencyErrorFile= filename [verbose=(TRUE |
FALSE)]
Parameters
Parameter
virtualDisk
consistencyErrorFile
verbose

Reset RAID Controller Module

This command resets a RAID controller module.
NOTE:
When you reset a RAID controller module, the RAID controller module is not
available for I/O operations until the reset is complete. If a host is using virtual disks
owned by the RAID controller module being reset, the I/O directed to the RAID
controller module is rejected. Before resetting the RAID controller module, either
verify that the virtual disks owned by the RAID controller module are not in use or
ensure a multipath driver is installed on all hosts using these virtual disks.
Syntax
reset controller [(0 | 1)]
Description
Name of the specific virtual disk for which to repair
consistency. You must put brackets ([ ]) around the virtual
disk name. If the virtual disk name has special characters, you
must also put quotation marks (" ") around the virtual disk
name.
Name of the file that contains the consistency error
information you use to repair the errors. You must put
quotation marks (" ") around the file name.
Captures progress details, such as percent complete, and
shows the progress detail information as virtual disk
consistency is being repaired. To capture progress details, set
this parameter to TRUE. To prevent capturing progress
details, set this parameter to FALSE.
Script Commands
157