Dell PowerVault MD3000i Cli Manual page 19

Table 1-2. Command Line Parameters (continued)
Parameter
-c
-d
-e
-F (uppercase)
-f (lowercase)
Definition
Use to indicate that you are entering one or more script
commands to run on the specified storage array. Terminate
each command by using a semicolon (;).
You cannot place more than one -c parameter on the same
command line. You can include more than one script
command after the -c parameter.
Use to display the contents of the script configuration file.
Use to disable syntax checking when executing the current
CLI command.
Use to specify the email address from which all alerts will
be sent.
Use to specify a file name containing script commands
intended to run on the specified storage array.
This parameter is similar to the -c parameter in that both
are intended for running script commands. The -c
parameter allows you to execute individual script
commands. The -f parameter allows you to execute script
commands contained in a file.
NOTE:
By default, any errors encountered when running the
script commands in a file are ignored, and the file continues
to run. To override this behavior, use the set session
errorAction=stop command in the script file.
About the Command Line Interface
19