Dell PowerVault MD3000i Cli Manual page 181

Parameters
Parameter
virtualDisk or virtualDisks
userLabel
warningThresholdPercent
repositoryFullPolicy
NOTE:
When using this command, you can specify one or more of the optional
parameters. You do not, however, need to use all of the parameters.
NOTE:
You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Description
Name of the specific snapshot virtual disk for
which to define properties. (You can enter more
than one snapshot virtual disk name by using the
virtualDisks parameter). You must put quotation
marks (" ") and brackets ([ ]) around the
snapshot virtual disk name. The snapshot virtual
disk name and quotation marks must be inside
the brackets.
New name to give to a snapshot virtual disk. You
must put quotation marks (" ") around the new
snapshot virtual disk name.
Percentage of repository capacity at which a
warning is given that the repository is nearing
full. Use integer values. For example, a value of
70 means 70 percent. The default value is 50.
NOTE:
You can set this parameter for both the
repository virtual disk and snapshot virtual disk.
Specifies the desired method of snapshot
processing if the repository is full. You can choose
to fail writes to the source virtual disk
(failSourceWrites) or fail writes to the snapshot
virtual disk (failSnapShot). The default value is
failSnapShot.
NOTE:
You can set this parameter for both the
repository virtual disk and snapshot virtual disk.
Script Commands
181