Dell PowerVault MD3000i Cli Manual page 38

Table 2-4. Recurring Syntax Elements (continued)
Recurring Syntax
nvsram-offset
host-type
nvsram-byte-setting
nvsram-bit-setting
ipv4-address
ipv6-address
autoconfigure-vols-attr-value-list
autoconfigure-vols-attr-value-pair
38
About the Script Commands
Syntax Value
hexadecimal-literal
string-literal | integer-literal
nvsram-value
(0x hexadecimal | integer-literal)
nvsram-mask, nvsram-value
(0x hexadecimal, 0x hexadecimal |
integer-literal)
(0–255).(0–255).(0–255).(0–255)
(0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFF)
autoconfigure-vols-attr-value-pair
{autoconfigure-vols-attr-value-pair}
physicalDiskType=physical disk-type|
raidLevel=raid-level |
diskGroupWidth=integer-literal |
diskGroupCount=integer-literal |
virtualDisksPerGroupCount=integer-
literal|
hotSpareCount=integer-literal |
segmentSize=segment-size-spec
NOTE:
The physicalDiskType parameter is
not required if only one type of physical
disk is in the storage array. If you use the
physicalDiskType parameter, you must
also use the hotSpareCount and
diskGroupWidth parameters. If you do not
use the physicalDiskType parameter, the
configuration defaults to SAS physical
disks.
NOTE:
The virtualDisksPerGroupCount
parameter is the number of equal-
capacity virtual disks per disk group.