Dell PowerVault MD3000i Cli Manual page 154

Parameters
Parameter
virtualDisk or virtualDisks
userLabel
warningThresholdPercent
repositoryFullPolicy
NOTE:
You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
NOTE:
If the warningThresholdPercent parameter or the repositoryFullPolicy
parameter is not specified, the previously set values are used. If you use the
optional parameters, the re-create Snapshot will process each snapshot virtual
disk separately. If the same userLabel (name) is specified for more than one virtual
disk, the command fails. If no optional parameters are specified, the re-create
154
Script Commands
Description
Name of the specific virtual disk for which to start a
fresh copy-on-write operation. You can enter more
than one virtual disk name. You must put
brackets ([ ]) around the virtual disk name. If the
virtual disk name has special characters, you
must also put quotation marks (" ") around the
virtual disk name.
Name of the snapshot virtual disk. You must put
quotation marks (" ") around the snapshot virtual
disk name. If you enter more than one snapshot
virtual disk name, this command fails.
Percentage of repository capacity at which you
receive a warning that the repository is nearing
full. Use integer values. For example, a value of
70 means 70 percent. The default value is
50 percent.
NOTE:
If warningThresholdPercent is not
specified, the previously set value is used.
Specifies how snapshot processing continues if
the repository is full. You can choose to fail writes
to the source virtual disk (failSourceWrites) or
fail writes to the snapshot virtual disk
(failSnapShot). The default value is
failSnapShot.
NOTE:
If repositoryFullPolicy is not specified, the
previously set value is used.