Dell PowerVault MD3000i Cli Manual page 133

Parameter
repositoryPhysicalDiskCount
physicalDiskType
repositoryDiskGroup
freeCapacityArea
userLabel
warningThresholdPercent
Description
Number of unassigned physical disks to
use for the repository virtual disk.
Type of physical disks to use for the
repository virtual disk. Valid physical disk
types are SAS or SATA.
Sequence number of the disk group where
the repository virtual disk is located.
The index number of the free space in an
existing disk group to use to create the
snapshot repository virtual disk. Free
capacity is defined as the free capacity
between existing virtual disks in a disk
group. For example, a disk group might
have the following areas: virtual disk 1,
free capacity, virtual disk 2, free capacity,
virtual disk 3, free capacity. To use the free
capacity following virtual disk 2, you
specify:
freeCapacityArea=2
Use the show diskGroup command to
determine if free capacity area exists.
NOTE:
If you do not specify the
unconfigured or free space, the repository
virtual disk is placed in the same disk group
as the source virtual disk. If the disk group
where the source virtual disk resides does
not have enough space, this command fails.
The name to give the snapshot virtual
disk. You must put quotation marks (" ")
around the snapshot virtual disk name.
The percentage of repository capacity at
which you receive a warning that the
repository is nearing full. Use integer
values. For example, a value of 70 means
70 percent. The default value is 50.
Script Commands
133