Upgrade Remaining Stand-Alone K2 Systems - GRASS VALLEY K2 7.3.8 - RELEASE NOTES AND Quick Start Manual

Release notes & upgrade instructions

page of 108

/ 108
Contents
Table of Contents
Bookmarks

Table of Contents

Upgrading K2 systems

Disable write filter

1. If you have not already done so, log on to the K2 system with Windows administrator privileges.

2. From the Windows desktop, click

FBWF Manager opens.

3. Under Filter Settings, set Filter to

Do not modify other settings.

4. Click

5. When prompted, restart the K2 system.

Uninstall K2 Dyno Server software

If you have not already done so, disable the write lter on the K2 Summit Production Client or K2

Solo Media Server.

On the K2 Summit Production Client or K2 Solo Media Server, use the Windows

Programs

The display name of the software is

Do not restart the K2 Summit Production Client or K2 Solo Media Server.

Install K2 Dyno Server software

If the K2 Dyno Server software was previously installed, you must uninstall the software before

you use these steps to install.

If you have not already done so, disable the write lter on the K2 Summit Production Client or K2

Solo Media Server.

1. From the K2 Summit Production Client or K2 Solo Media Server, access the K2 Dyno Server

software installation les.

2. In the Server directory, locate and open the following le:

setup.exe

3. Follow the onscreen instructions, and work through each page.

4. Click

5. Restart the K2 Summit Production Client or K2 Solo Media Server.

6. On the K2 Summit Production Client or K2 Solo Media Server, in Con guration Manager on

the Ganging tab, make sure that

on all channels of Gang

NOTE: The K2 Dyno Controller can exhibit behavior that is dif cult to troubleshoot if this

checkbox is selected.