Table of Contents
Advertisement
Upgrading K2 systems
9. If you previously uninstalled SNFS manually because SNFS was on C:, copy directories/ les
from C: to D:, overwriting les on D:, as follows.
a) Copy the
b) Copy the
c) A restart is required to put the change into effect. If you do a subsequent upgrade task that
d) After the entire K2 SAN upgrade process is complete, test media access. If successful, delete
Verify/upgrade switch firmware
Do not do this task if:
Your HP ProCurve 29xx series switch already has the current required rmware version.
Do this task if:
Your HP ProCurve 29xx series switch does not have the current required rmware version.
Refer to compatibility information earlier in these release notes for rmware version requirements.
1. Telnet to the switch and login with the administrator username and password.
2. At the switch console command (CLI) prompt, type the following, then press
menu
If prompted to save the current con guration, answer no (press the n key) to proceed.
The main menu opens.
3. From the main menu, tab to
4. Check the version of rmware on the switch. To do this, type the following, then press
show flash
Information is displayed similar to the following example:
HP_iSCSI_switch1# show flash
Image
-----
Primary Image
Secondary Image : 5886358
Boot Rom Version: K.12.12
Current Boot
5. Check the Primary Image Version and refer to compatibility information earlier in these release
notes. If instructed to change the rmware on the switch, do so before continuing.
Related Links
Upgrading rmware on HP switch
Con guring QOS on the GigE switch
54
K2 Version 7.3.8 Release Notes & Upgrade Instructions
C:\SNFS\config
C:\SNFS\data
adequate time to complete the copy operation.
also requires a restart, that restart is suf cient. Otherwise restart now.
the
directory and its les on the K2 Media Server.
C:\SNFS
Size(Bytes)
----------
: 6737518
: Primary
directory to
D:\SNFS\config
directory to
D:\SNFS\data
and press
Command Line (CLI)
Date
Version
--------
-------
07/25/08
T.13.23
10/26/06
T.11.12
on page 27
on page 28
.
. This directory can be large, so allow
Enter
. The command prompt appears.
Enter
23 November 2010
:
:
Enter
Hide quick links:
Advertisement
Table of Contents
