GRASS VALLEY K2 7.3.8 - RELEASE NOTES AND Quick Start Manual page 29

2. Type the following, then press
config
You are now in con guration mode.
3. Type the following, then press
qos queue-con g 2-queues
This limits the number of active queues within the switch giving the most buffering to VLANs
1 and 60
4. Type the following, then press
show qos vlan
The screen displays VLAN information. Note the ID number of the Media (iSCSI) VLAN. It
should be 60, as follows:
VLAN priorities
5. a) Assign the Media VLAN the QOS priority of 3. For example, if the VLAN ID is 60, you type
b) Type the following, then press
Next, verify ow control settings.
23 November 2010
VLAN ID Apply rule
------- ----------- + ------ -----------
1 No-override |
60 No-override |
the following, then press
vlan 60 qos priority 3
show qos vlan
The screen displays VLAN information. Make sure that the Priority column reports that the
Media VLAN has a value of 3.
:
Enter
:
Enter
:
Enter
| DSCP Priority
No-override
No-override
.
Enter
:
Enter
K2 Version 7.3.8 Release Notes & Upgrade Instructions
Additional notes
29