Lock K2 Summit Production Clients - GRASS VALLEY K2 7.3.8 - RELEASE NOTES AND Quick Start Manual

Upgrading K2 systems
Uninstall K2 Dyno Server software
If you have not already done so, disable the write lter on the K2 Summit Production Client or K2
Solo Media Server.
On the K2 Summit Production Client or K2 Solo Media Server, use the Windows
Programs
The display name of the software is
Do not restart the K2 Summit Production Client or K2 Solo Media Server.
Install K2 Dyno Server software
If the K2 Dyno Server software was previously installed, you must uninstall the software before
you use these steps to install.
If you have not already done so, disable the write lter on the K2 Summit Production Client or K2
Solo Media Server.
1. From the K2 Summit Production Client or K2 Solo Media Server, access the K2 Dyno Server
software installation les.
2. In the Server directory, locate and open the following le:
setup.exe
3. Follow the onscreen instructions, and work through each page.
4. Click
5. Restart the K2 Summit Production Client or K2 Solo Media Server.
6. On the K2 Summit Production Client or K2 Solo Media Server, in Con guration Manager on
the Ganging tab, make sure that
on all channels of Gang
NOTE: The K2 Dyno Controller can exhibit behavior that is dif cult to troubleshoot if this
checkbox is selected.

Lock K2 Summit Production Clients

This task enables the write lter on a K2 Summit Production Client or on a group of K2 Summit
Production Clients.
Prerequisites for this task are as follows:
The device or all the devices in the group are communicating correctly in SiteCon g. This is
indicated by the green star icon overlay.
The device or all the devices in the group are currently unlocked. This is indicated by the red
lock icon overlay.
1. In the
tree view, identify the device or the group of devices that you intend to lock.
2. Right-click the device or the group and select
A
80 K2 Version 7.3.8 Release Notes & Upgrade Instructions
control panel and uninstall K2 Dyno Server software.
and to complete the installation.
Next Finish
is not selected.
Network Configuration | Devices
may require restart message appears.
.
K2 Dyno
Use a single channel to control the gang
tree view or the
Software Deployment | Deployment Groups
.
Lock
Add/Remove
or
Record/play same clip
23 November 2010