Make Recovery Images; Prepare Siteconfig For Software Deployment To K2 San Devices - GRASS VALLEY K2 7.3.8 - RELEASE NOTES AND Quick Start Manual

Make recovery images

Do not do this task if:
You previously made a recovery image at the current software version for each computer you
are upgrading.
Do this task if:
You do not have a recovery image at the current software version for one or more of the computers
you are upgrading.
The recommended procedure is to make a recovery image immediately after a software upgrade. If
you neglected to do this when you last upgraded software you should make the recovery image now,
before upgrading to the new version.
Refer to the Grass Valley product's Service Manual for recovery image procedures.
CAUTION: If you upgrade and then decide you do not want to stay with this version of K2
system software, you must use the recovery disk image process to downgrade to your previous
version.

Prepare SiteConfig for software deployment to K2 SAN devices

Do the following to prepare SiteCon g for the software upgrade.
1. Make the following les accessible to the SiteCon g control point PC:
2. On the K2 Media Server, check for the
3. If a newer version of SiteCon g is available for upgrade and you have not yet upgraded
SiteCon g, do the following:
a) From Windows Add/Remove programs, uninstall the current version of SiteCon g from the
b) Install the new version of SiteCon g on the control point PC.
23 November 2010
K2 Summit Client SAN software installation (
K2 Media Server software installation (
systems and le with
x64
SNFS software installation (
le with in lename for 64-bit systems.
x64
Summit SNFS software installation (
Control Point software installation (
If exists on the K2 Media Server, then SNFS 3.5.1 is on the C: drive. In this case
C:\SNFS
you must move SNFS to the D: drive. To do this you must procure the
use it as instructed with special tasks in the upgrade process below. The
on the version 7.3.8.xxxx K2 software CD in the SNFS directory. It can also be obtained at
http://www.grassvalley.com/downloads
If does not exist on the K2 Media Server, continue with this procedure. No special
C:\SNFS
tasks are required.
control point PC.
*.cab
) le. Use le with
*.cab
in lename for 64-bit systems.
) le. Use le with
*.cab
) le.
*.cab
) le.
*.cab
directory and then proceed as follows:
C:\SNFS
.
K2 Version 7.3.8 Release Notes & Upgrade Instructions
Upgrading K2 systems
) le.
in lename for 32-bit
x86
in lename for 32-bit systems and
x86
35c235d.reg
35c235d.reg
le and
le is
43