Reset Capture Services - GRASS VALLEY K2 7.3.8 - RELEASE NOTES AND Quick Start Manual

Upgrading K2 systems
2. If an upgrade is required, continue with this procedure to upgrade disk drive rmware.
Refer to the K2 SAN Installation and Service Manual for complete procedures.
3. In Storage Utility, right-click a controller in the tree view, then select
Firmware
NOTE: You can download rmware to a single disk by right-clicking a disk icon in the tree
view.
The Open File dialog box opens.
4. In the Open File dialog box, browse to the desired rmware le for your disks, select the le,
and click
As instructed by a message that appears, watch the lights on the drives. For each drive, one at a
time, the lights ash as rmware loads. Wait until the lights on all the drives on which you are
downloading rmware have completed their ashing pattern. This can take several minutes.
The Progress Report window appears showing the disk rmware download task and the percentage
complete.
5. When nished, restart the K2 Media Server.

Reset Capture Services

Do not do this task if:
You do not use any of the K2 Capture Services.
Do this task if:
You are using one or more K2 Capture Services, such HotBin, Path re, DG, XML Import,
Export, P2, etc
Do this task on the K2 system running your K2 Capture Service, which is the K2 system that receives
the media to be imported into K2 storage. This can be a K2 Solo Media Server, a stand-alone K2
Summit Production Client, or the K2 Media Server with the role of primary FTP server on a K2
SAN.
When you con gure a K2 Capture Service for the rst time, the service is set to startup type
Automatic. However, if you upgrade or otherwise re-install your K2 System Software, the service
is re-set to startup type Manual. Therefore, you must re-con gure the service after K2 System
Software upgrade/ reinstall in order to set the startup type back to Automatic.
1. From the
On a K2 Summit/Solo system, if the write lter is enabled, a message appears that informs you
about the write lter and prompts you to restart. Restart as prompted, then repeat this step.
The K2 Capture Services utility dialog box is displayed.
2. Click
On a K2 Summit/Solo system, a message appears that informs you about the write lter and
prompts you to restart. Click
For import capture services, the service checks the source directory for les. If les are present,
the service moves them to the Archive sub-directory. It does not import the les into the
destination bin on the K2 system.
56 K2 Version 7.3.8 Release Notes & Upgrade Instructions
in the context menu.
.
OK
menu, access the
Start
.
Apply
OK
menu and select
Programs
and the K2 Summit/Solo system restarts.
Advanced | Download Disk
Grass Valley | K2 Capture Services
23 November 2010
.