GRASS VALLEY K2 7.3.8 - RELEASE NOTES AND Quick Start Manual page 51

Software
SNFS software for
64-bit systems
You can add les for both 32 bit and 64 bit systems because when SiteCon g deploys software it
automatically deploys the 32 bit or 64 bit software appropriate for the target device. You must install
SNFS as a separate cab le.
1. In the
2. Click the
The Add Package(s) dialog box opens.
3. Do one of the following to select the software package:
4. If one or more EULAs are displayed, accept them to proceed. If you do not accept a EULA, the
associated software is not assigned to the deployment group.
SiteCon g adds the package to the deployment group.
The package appears in the Managed Packages list for the selected deployment group. SiteCon g
creates new software deployment tasks for the package and displays them in the Tasks list view.
Upgrade software on K2 Media Servers
Prerequisites for this task are as follows:
The devices that you are upgrading are in a deployment group.
For the software you are upgrading, you have added a newer version of that managed software
package to the deployment group.
If SNFS was on C:, you have uninstalled SNFS manually as instructed earlier in this upgrade
procedure.
You have recently done the SiteCon g "Check Software" operation on the devices you are
upgrading.
NOTE: On a K2 system, if a SNFS version lower than 3.0 is installed, do not uninstall using
SiteCon g. You must manually uninstall using a special batch le. Follow instructions in the
release notes for your current version of K2 software.
If you are upgrading multiple software components for which there is a required sequence, you must
check and uncheck tasks and run multiple deployment sessions to control the sequence. For some
software components, SiteCon g aids you by enforcing dependencies. For each individual software
component, SiteCon g enforces an uninstall of the current version of software before installing the
upgrade version. SiteCon g provides uninstall deployment tasks and install deployment tasks to
indicate the task ow. SiteCon g can do the uninstall/install in a single deployment session.
1. In the
devices to which you are deploying software.
The corresponding software deployment tasks are displayed in the Tasks list view.
2. For the software you are deploying, select the
23 November 2010
File name
SNFS_x64_3.5.2.1b15620.cab
Software Deployment | Deployment Groups
button.
Add
Select from the list of packages then click
Click , browse to and select the package, then click
Browse
Software Deployment | Deployment Groups
tree view, select a deployment group.
.
OK
Open
tree view, select the device or the group of
check box in the row for the uninstall task.
Deploy
K2 Version 7.3.8 Release Notes & Upgrade Instructions
Upgrading K2 systems
.
51