Install Snfs On Stand-Alone K2 System; Verify Upgraded Software - GRASS VALLEY K2 7.3.8 - RELEASE NOTES AND Quick Start Manual

9. Click
10. When prompted to restart, proceed as follows:

Install SNFS on stand-alone K2 system

Prerequisites for this task are as follows:
Before installing a new version of SNFS software, make sure that the computer has been restarted
at least once since the previous version of SNFS software was uninstalled.
1. Access the installation les.
2. Press any key to proceed.
3. Restart media le system services as follows:
a) Click
b) Click
4. Restart the computer using the Windows operating system restart procedure.

Verify upgraded software

When the K2 client starts up, you can verify that the correct versions of software are installed as
follows:
1. Log on to AppCenter.
2. In AppCenter click
The About dialog box opens.
3. Identify versions as follows
System Version
RTS Version
Media File System
23 November 2010
and to complete the installation.
Next Finish
Disable the write lter.
Disabling the write lter before the restart keeps it disabled after restart. This is helpful
because it must be disabled in order to install software, which you will be doing after the
restart.
Do one of the following:
If the version from which you are upgrading is lower than 7.1.0.1153, shut down the
system. After the system is shut down, press the standby button to power up the system.
You must shutdown/powerup (power cycle), rather than restart.
If the version from which you are upgrading is 7.1.0.1153 or higher, restart.
Start | Programs | SNFS File System | Services Stop
Start | Programs | SNFS File System | Services Start
Help | About
.
7.3.8.xxx
7.3.8.xxx
3.5.2.1b15620
K2 Version 7.3.8 Release Notes & Upgrade Instructions
Upgrading K2 systems
.
.
These should both report the
same version number. This is
the K2 System Software
version number.
This is the SNFS version.
89