Upgrade K2 Dyno Server Software - GRASS VALLEY K2 7.3.8 - RELEASE NOTES AND Quick Start Manual

Do this task if:
You are using one or more K2 Capture Services, such HotBin, Path re, DG, XML Import,
Export, P2, etc
Do this task on the K2 system running your K2 Capture Service, which is the K2 system that receives
the media to be imported into K2 storage. This can be a K2 Solo Media Server, a stand-alone K2
Summit Production Client, or the K2 Media Server with the role of primary FTP server on a K2
SAN.
When you con gure a K2 Capture Service for the rst time, the service is set to startup type
Automatic. However, if you upgrade or otherwise re-install your K2 System Software, the service
is re-set to startup type Manual. Therefore, you must re-con gure the service after K2 System
Software upgrade/ reinstall in order to set the startup type back to Automatic.
1. From the
On a K2 Summit/Solo system, if the write lter is enabled, a message appears that informs you
about the write lter and prompts you to restart. Restart as prompted, then repeat this step.
The K2 Capture Services utility dialog box is displayed.
2. Click
On a K2 Summit/Solo system, a message appears that informs you about the write lter and
prompts you to restart. Click
For import capture services, the service checks the source directory for les. If les are present,
the service moves them to the Archive sub-directory. It does not import the les into the
destination bin on the K2 system.

Upgrade K2 Dyno Server software

Do not do the tasks in this section if:
The K2 Summit Production Client or K2 Solo Media Server is not controlled by a K2 Dyno
Controller and therefore K2 Dyno Server software is not installed.
Do the tasks in this section if:
The K2 Summit Production Client or K2 Solo Media Server is controlled by a K2 Dyno Controller
and you need to upgrade the K2 Dyno Server software. Refer to compatibility speci cations to
determine if you need to upgrade.
Check the K2 Dyno Controller release notes for any updated information regarding the upgrade
process, then proceed with the tasks in this section.
About K2 Dyno software
There are two software components in the K2 Dyno Replay system, as follows:
K2 Dyno Server software This software runs on the K2 Summit/Solo that is controlled by the
K2 Dyno Controller.
K2 Dyno Client software This software runs on the K2 Dyno Controller.
When installing/upgrading K2 Dyno software you must consider versions and compatibility for
both components: one on the K2 Summit/Solo and one on the K2 Dyno Controller.
23 November 2010
menu, access the
Start
.
Apply
OK
menu and select
Programs
and the K2 Summit/Solo system restarts.
K2 Version 7.3.8 Release Notes & Upgrade Instructions
Upgrading K2 systems
Grass Valley | K2 Capture Services
.
97