Configuring Qos On The Gige Switch - GRASS VALLEY K2 7.3.8 - RELEASE NOTES AND Quick Start Manual

Additional notes
4. Execute the copy command with the following syntax:
copy tftp flash <ip-address> <remote-os-file> [ < primary | secondary
> ]
Note that if you do not specify the ash destination, the TFTP download defaults to the primary
ash.
For example, to download a software le named T_13_23.swi from a TFTP server with the IP
address of 10.16.34.3 1, use the following:
ProCurve # copy tftp flash 10.16.34.3 T_13_23.swi
5. When prompted
.
Y
When the switch nishes downloading the software le from the server, it displays the progress
message
6. Wait until the CLI prompt re-appears, then continue with the next step in this procedure.
7. Check the version of rmware on the switch. To do this, type the following, then press
show flash
Information is displayed similar to the following example:
HP_iSCSI_switch1# show flash
Image
-----
Primary Image
Secondary Image : 5886358
Boot Rom Version: K.12.12
Current Boot
8. Verify that the new software version is in the expected ash area (primary or secondary).
9. Restart the switch from the ash area that holds the new software (primary or secondary).

Configuring QOS on the GigE switch

Prerequisites for this procedure are as follows:
The switch is HP ProCurve switch 29xx series.
Trunks, VLANs and all other con guration is complete.
The switch has an IP address
You have network access to the switch
Use this procedure to make the Quality of Service (QOS) setting on the HP ProCurve switch 29xx
series.
1. If you have not already done so, from a network connected PC open the MS-DOS command
prompt and login to the switch as administrator, as follows:
a) Telnet to the switch. For example, if the switch s IP address is 192.168.40.12, you type the
b) Press
c) Type the switch s administrator username and press
28 K2 Version 7.3.8 Release Notes & Upgrade Instructions
The primary OS image will be deleted. continue [y/n]?
Validating and Writing System Software to FLASH...
Size(Bytes)
----------
: 6737518
: Primary
following, then press
Enter
telnet 192.168.40.12
one or more times until the switch s username prompt appears.
Enter
password and press
Enter
Date Version
-------- -------
07/25/08 T.13.23
10/26/06 T.11.12
.
. The switch console command (CLI) prompt appears.
, then type the switch s administrator
Enter
, press
:
Enter
23 November 2010