Saving The Configuration; Reminders - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

Saving the configuration

In addition to applying the configuration changes, you can save them to flash memory on the switch.
IMPORTANT:
rebooted.
To save the new configuration, enter the following command at any prompt:
# save
When you save configuration changes, the changes are saved to the active configuration block. The
configuration being replaced by the save is first copied to the backup configuration block. If you do not
want the previous configuration block copied to the backup configuration block, enter the following
instead:
# save n
You can decide which configuration you want to run the next time you reset the switch. Your options
include:
The active configuration block
The backup configuration block
Factory default configuration block
You can view all pending configuration changes that have been applied but not saved to flash memory
using the diff flash command. It is a global command that can be executed from any prompt.
For instructions on selecting the configuration to run at the next system reset, see the "Selecting a
configuration block" section in the "Boot Options Menu" chapter.

Reminders

CLI reminders prompt users to complete configuration tasks that require multiple steps. The default setting
for CLI reminders is enabled. Use the following command to disable CLI reminders:
/cfg/sys/reminders dis
The following is an example of a configuration task performed with CLI reminders enabled.
>> Layer 2# vlan 5
VLAN number 5 with name "VLAN 5" created.
Reminder: VLAN 5 needs to be enabled.
>> VLAN 5# add 9
Port 9 is an UNTAGGED port and its current PVID is 1.
Confirm changing PVID from 1 to 5 [y/n]: y
Current ports for VLAN 5:
Pending new ports for VLAN 5:
Reminder: Port 9 needs to be enabled.
Reminder: VLAN 5 needs to be enabled.
If you do not save the changes, they will be lost the next time the system is
empty
9
Configuration Menu
105