Forwarding Database Configuration; Static Fdb Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Spanning Tree Port Configuration commands
Table 110
Command
[no] spanning-tree stp
{<1-128>} edge
spanning-tree stp {<1-128>}
fastforward
spanning-tree stp {<1-128>}
enable
no spanning-tree stp
{<1-128>} enable
show interface port {<port
number>} spanning-tree stp
{<1-128>}

Forwarding Database configuration

The following table describes the Forwarding Database Configuration commands.
FDB Configuration commands
Table 111
Command
aging <0-65535>
show mac-address-table

Static FDB configuration

The following table describes the Static FDB Configuration commands.
Static FDB Configuration commands
Table 112
Command
mac-address-table static
[<MAC address> vlan <VLAN>
port <port>]
no mac-address-table static
[<MAC address>| all]
Description
Enables or disables this port as an edge port. An edge port is not
connected to a bridge, and can begin forwarding traffic as soon as the
link is up. Configure server ports as edge ports (enabled).
This command only applies when RSTP is turned on. See the "Common
Internal Spanning Tree configuration" section for more information.
Command mode: Interface port
Enables or disables Port Fast Forward on the port.
Command mode: Interface port
Enables STP on the port.
Command mode: Interface port
Disables STP on the port.
Command mode: Interface port
Displays the current STP port parameters.
Command mode: All
Description
Configures the aging value for FDB entries. The default value is 300.
Displays current FDB parameters.
Description
Adds a static entry to the forwarding database.
Command mode: Global configuration
Deletes a static entry from the forwarding database.
Command mode: Global configuration
Configuration Commands
137