Converting An In-Use Phone From Sccp To Sip; Converting An In-Use Phone From Sip To Sccp - Cisco 7961G-GE - IP Phone VoIP Administration Manual

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Step 2
Step 3

Converting an In-Use Phone from SCCP to SIP

Converting an In-Use Phone from SIP to SCCP

Step 1
Step 2
Step 3
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
OL-11953-01
Refer to Cisco Unified Communications Manager Administration Guide for
detailed information about Cisco Unified Communications Manager
configuration. Refer to Cisco Unified Communications Manager Bulk
Administration Guide for detailed information about using the BAT.
If you are not using DHCP in your network, configure the network parameters for
the phone.
See the "Configuring Startup Network Settings" section on page 3-14.
Power cycle the phone.
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use
in your network from SCCP to SIP. To access BAT from Cisco Unified
Communications Manager Administration, choose Bulk Administration >
Phones > Migrate Phones > SCCP to SIP. For detailed information, refer to
Cisco Unified Communications Manager Bulk Administration Guide.
To convert a phone that is in use in your network from SIP to SCCP, perform these
steps. For more information, Cisco Unified Communications Manager
Administration Guide.
Procedure
In Cisco Unified Communications Manager Administration, delete the existing
SIP phone from the Cisco Unified Communications Manager database.
In Cisco Unified Communications Manager Administration, create the phone as
an SCCP phone.
Power cycle the phone.
Using Cisco Unified IP Phones with Different Protocols
2-19