Cisco 7961G-GE - IP Phone VoIP Administration Manual page 102

Network Configuration Menu
Table 4-2 Network Configuration Menu Options (continued)
Option Description
TFTP Server 2 Optional backup TFTP server that the phone
uses if the primary TFTP server is unavailable.
If neither the primary TFTP server nor the
backup TFTP server is listed in the CTL file on
the phone, you must unlock the CTL file before
you can save changes to the TFTP Server 2
option. In this case, the phone will delete the
CTL file when you save changes to the TFTP
Server 2 option.
For information about the CTL file, refer to
Cisco Unified Communications Manager
Security Guide. For information about
unlocking the CTL file, see to the
Configuration Menu" section on page
Default Router 1 Default router used by the phone (Default
Router 1) and optional backup routers (Default
Default Router 2
Router 2–5).
Default Router 3
Default Router 4
Default Router 5
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.0
4-10
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
1.
2.
3.
4.
5.
"Security
4-37.
1.
2.
3.
4.
5.
6.
Unlock the CTL file, if
necessary.
Unlock network
configuration options.
Enter an IP address for the
TFTP Server 1 option.
Scroll to the TFTP Server 2
option, press the Edit
softkey, and then enter a new
backup TFTP server IP
address.
Press the Validate softkey,
and then press the Save
softkey.
Unlock network
configuration options.
Set the DHCP Enabled
option to No.
Scroll to the appropriate
Default Router option, press
the Edit softkey, and then
enter a new router IP
address.
Press the Validate softkey.
Repeat Steps 3 and 4 as
needed to assign backup
routers.
Press the Save softkey.
OL-11953-01