Stop Recording - Yamaha A4000 Owner's Manual

ESSENTIAL PROCEDURES
14.

Stop Recording

If you selected the "Manual" Stop Trigger mode, recording will stop as soon as you press Knob 5
(FINISH). If you selected the "Edge/Manual" Stop Trigger mode in step 10, recording will stop auto-
matically as soon as the input signal level drops below the specified Edge Level. If the recording is not
going as expected and you want to stop and try again, press Knob 3 (ABORT) to abort the record oper-
ation without saving the recorded data to memory.
• When you record a sample as described in the above procedure, the recorded data is saved to the
sampler's volatile memory and will be lost if the power is turned off before the data is saved to
disk. See page 208 for information on saving recorded samples to disk.
Step-by-Step
TRIMMING
Trimming allows you to "trim" away unwanted portions of the recorded sound, leaving only the sound you
want to use.
1.
Go To the TRIM/LOOP Display
Press the [EDIT] button and then the [TRIM/LOOP] function key to go to the "EDIT-Waveform" dis-
play.
42
Chapter 2 Sampler Basics & Essential Procedures
• A5000/A4000