Power Connection - Yamaha A4000 Owner's Manual

Power Connection

This page shows you how to connect up the power cord that comes with the A5000/A4000.
• Be sure that the A5000/A4000's power switch is OFF before you attach the cord. (The switch is
OFF when it is all the way out.)
• The A5000/A4000 is designed for use with a grounded line (three-prong outlet).
Connecting the Cord
Connect the supplied power cord to the AC inlet on the rear panel. Then plug the other end of the cord into
a 3-prong wall outlet.
WARNING
• Make sure your A5000/A4000 is rated for the AC voltage supplied in the area in which it is to be used (as
listed on the rear panel). Connecting the unit to the wrong AC supply can cause serious damage to the
internal circuitry and may even pose a shock hazard!
• Use only the AC power cord supplied with the A5000/A4000. If the supplied cord is lost or damaged and
needs to be replaced, contact your Yamaha dealer. The use of an inappropriate replacement can pose a fire
and shock hazard!
• The type of AC power cord provided with the A5000/A4000 may be different depending on the country in
which it is purchased (a third prong may be provided for grounding purposes). Improper connection of the
grounding conductor can create the risk of electrical shock. Do NOT modify the plug provided with the
A5000/A4000. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician. Do
not use a plug adaptor which defeats the grounding conductor.
Wall Outlet
Power Cord
Rear Panel
AC INLET
A5000/A4000 •

Power Connection

19
Chapter 1 Setting Up