Copy Volume - Yamaha A4000 Owner's Manual

COPY VOLUME

[DISK] Button [COMMAND/EXIT] Button
Knob 1 to highlight display line 1
Copies all data in a selected volume to a separate volume.
Floppy disk volumes cannot be selected as the copy source or
destination. Also, volumes on disks which were not formatted
by the A5000/A4000 cannot be copied.
[Operation]
1.
Use Knob 3 to specify the Copy Type.
2.
Use Knob 1 (EXEC) or Knob 5 (EXEC&CONT) to initiate execu-
tion. When the confirmation display appears, press Knob 5 (YES)
to execute the copy operation.
• If Knob 1 (EXEC) is used to execute the command, the command
menu will be recalled after execution has finished. If Knob 5
(EXEC&CONT) is used to execute the command, the copy volume
display will be retained so you can continue and copy other vol-
umes.
Cursor q
Cursor
q
Knob 1 Knob 2
Turn
Cursor —
action
Press
EXEC —
action
Knob 1
[ Turn] Cursor
Positions the cursor.
[ Press] EXEC (Execute)
Press this knob to call the copy volume confirmation dis-
play. Press Knob 5 (YES) to actually execute the copy
volume operation.
Knob 3
[ Turn] Copy Type
Specifies whether one volume is to be copied, or all vol-
umes on the selected disk.
[Range] OneVolume, AllVolume
• OneVolume ... Only the single specified volume is
copied. Any previous data in the destination
volume will be erased and overwritten by the
copied data.
• AllVolume ... All volumes on the selected disk will
be copied. Any previous data on the destina-
tion disk will be erased and overwritten by the
copied data.
Press Knob 4
Knob 3 Knob 4 Knob 5
Copy Type — —
— — EXEC&CONT
Knob 5
[ Press] EXEC&CONT (Execute & Continue)
Press this knob to call the copy volume confirmation dis-
play. Press Knob 5 (YES) to actually execute the copy
volume operation.
Cursor w
Cursor
w
Knob 1 Knob 2
Turn
Cursor —
action
Press
EXEC —
action
Knob 1
Same function as Cursor
Knob 3
[ Turn] To Disk
Selects the destination hard disk, ZIP disk, or similar
medium to which the data is to be copied.
[Range] All connected/mounted disks.
Knob 5
[ Turn] To Volume
Selects the destination volume to which the data is to be
copied.
[Range] A volumes on the disk specified by the To Disk
parameter.
• This parameter cannot be set when the AllVolume
Copy Type is selected.
[ Press] EXEC&CONT (Execute & Continue)
Press this knob to call the copy volume confirmation dis-
play. Press Knob 5 (YES) to actually execute the copy
volume operation.
A5000/A4000 •
7. DISK COMMANDS
Knob 3 Knob 4 Knob 5
To Disk — To Volume
— — EXEC&CONT
q
(page 181).
181
Chapter 7 DISK Mode