Yamaha A4000 Owner's Manual page 41

11.
Go To the Record Display
Press the [RECORD] function key to go to the "REC-Record" display. In this display the "RECORD"
value is the total number of seconds that can be recorded as a single sample (the corresponding mem-
ory size in kilobytes appears in parentheses following the seconds value).
12.
Go To the Record Standby Display
Press Knob 5 (GO) to go to the record standby display. The "WAIT TRIG" indicator in the display will
be highlighted while the A5000/A4000 waits for recording to be triggered either automatically or man-
ually.
13.
Start Recording
If you selected the "Edge/Manual" Start Trigger mode in step 10, recording will begin automatically as
soon as the input signal level exceeds the specified Edge Level. If you selected the "Manual" Start
Trigger mode, recording will begin as soon as you press Knob 4 (START). The "RECORDING" indi-
cator in the display will be highlighted while recording is in progress.
Chapter 2 Sampler Basics & Essential Procedures
A5000/A4000 •
ESSENTIAL PROCEDURES
41