Register - Yamaha A4000 Owner's Manual

About the COMMANDS
Cursor w
(when the FreezeType is SampleBank&LpMode
ples, SampleBank Samples, and LpMode
Cursor
w
Knob 1 Knob 2
Turn
Cursor —
action
Press
EXEC —
action
Knob 1
Same function as Cursor
Knob 3
[ Turn] From SampleBank
Selects the source Sample Bank for the freeze operation.
All Sample Banks in memory can be selected.
Knob 4
[ Turn] Loop Mode
Sets the Loop Mode. When the Freeze command is exe-
cuted the Loop Mode settings of all samples within the
target Sample Bank are set accordingly. All Loop Modes
can be selected (page 123).
• This parameter can only be used when the Freeze
Type is set to SampleBank&LpMode Samples or
LpMode Samples.
Knob 5
Same function as Cursor
214
Chapter 9 COMMAND
Sam-
Samples)
Knob 3 Knob 4 Knob 5
From
Loop Mode —
SampleBank
— — EXEC&CONT
q
(page 213).
q
(page 213).
• A5000/A4000

REGISTER

[COMMAND/EXIT] Button
Knob 1 to highlioght display line 2
This command registers the initial EFFECT, SETUP, and
CONTROL function settings which will be recalled whenever
the power is turned on or when a program is initialized (page
217) from the specified source program. It also registers the
initial sample parameters which will be recalled whenever a
sample is recorded (page 151) or imported (page 175) from
the specified source sample.
• If, for example, you want reverb to be ON whenever the power is
turned on or a program is initialized, use the following procedure:
1.
Create a program that uses reverb.
2.
Go to the REGISTER page and select Program as the
Regist Type.
3.
Select the program created in step
Program, and set the Regist Source EFFECT parame-
ter to SourcePgm.
4.
Execute the Register command.
• The registered settings are retained even when the power is turned
off.
• When new settings are registered the previously registered settings
are erased and overwritten.
[Operation]
1.
Select the Regist Type (page 215).
2.
Make other settings as required.
3.
Press Knob 1 (EXEC) or Knob 5 (EXEC&CONT), and the register
confirmation display will appear. Press Knob 5 (YES) to execute
the register operation.
• If Knob 1 (EXEC) is used to execute the command, the display
previous to the command menu will be recalled after execution
has finished. If Knob 5 (EXEC&CONT) is used to execute the
command, the register display will be retained so you can con-
tinue and perform further register operations.
Cursor q
Cursor
q
Knob 1 Knob 2
Turn
Cursor Regist Type
action
Press
EXEC —
action
Knob 1
[ Turn] Cursor
Positions the cursor.
[ Press] EXEC
Press this knob to call the register confirmation display.
Press Knob 5 (YES) to actually execute the register oper-
ation.
Press Knob 3.
1
as the Source
Knob 3 Knob 4 Knob 5
— — —
— — EXEC&CONT