Yamaha A4000 Owner's Manual page 229

Knob 3
[ Turn] Sample
Selects the sample or sample bank to be exported. When
a sample bank is selected, all samples contained in that
sample bank are exported.
[Range] All samples in memory.
[ Press] UP
Press this knob to move upward from the current disk
directory to the next highest directory.
• Pressing the UP knob will have no effect if the top
(root) directory on the disk is selected.
Knob 4, 5
Same function as Cursor
e
Cursor
Cursor
e
Knob 1 Knob 2
Turn
Cursor Disk
action
Press
EXEC —
action
Knob 1
Same function as Cursor
Knob 2
[ Turn] Disk
Selects the floppy disk, hard disk, or other storage media
to which the data is to be exported. When a disk is
selected, all directories it contains are listed below the
disk name, and all programs contained in the selected
volume are listed on the right side of the display. When a
hard disk, CD-ROM drive or similar storage device is
selected, the SCSI ID number or IDE M/S (Master/Slave)
status of the device is shown to the right of the disk
name.
[Range] All installed/connected disks.
• Data can only be exported to MS-DOS format floppy
disks, hard disks, or similar media.
• If a connected SCSI device cannot be selected, go to
the disk select display (DISK-DISK-Disk) and check
the mount/unmount status and SCSI ID settings of
the device (page 173).
Knob 3
[ Press] UP
Press this knob to move upward from the current disk
directory to the next highest directory.
• Pressing the UP knob will have no effect if the top
(root) directory on the disk is selected.
q
(page 228).
Knob 3 Knob 4 Knob 5
— File/Directory —
UP DOWN EXEC&CONT
q
(page 228).
Knob 4, 5
Same function as Cursor
A5000/A4000 •
About the COMMANDS
q
(page 228).
229
Chapter 9 COMMAND