Initialize - Yamaha A4000 Owner's Manual
Professional sampler
Hide thumbs
Also See for A4000:
- Owner's manual (27 pages) ,
- Supplementary manual (25 pages) ,
- Service manual (61 pages)
Table of Contents
Advertisement
Knob 5
[
Turn] Sample
Specifies the sample (sample bank) to be transmitted via
the Bulk Dump operation.
All samples (sample banks) in memory can be selected.
• This parameter can only be used when the Bulk Type
is set to Sample.
[
Press] EXEC&CONT
Press this knob to call the bulk dump confirmation dis-
play. Press Knob 5 (YES) to actually execute the bulk
dump operation.
INITIALIZE
[COMMAND/EXIT] Button → Knob 1 to highlight display line 2
→ Press Knob 5.
Use this screen to initialize one or all memory-resident pro-
grams.
• Initialization removes all sample assignments (sets all ToPgm
switches to OFF), clears all Easy Edit settings, and returns the
EFFECT, SETUP, and CONTROL settings to the initial values
selected at the REGISTER page (page 214). (If you have not set
any REGISTER values, then EFFECT, SETUP, and CONTROL set-
tings revert to their factory defaults)
[Operation]
1.
Select the Init Type (page 217).
2.
If the Init Type is OneProgram, specify the program to be initialized
(page 217).
3.
Specify whether to initialize from the Register settings, or from the
factory preset settings (page 217).
4.
Press Knob 1 (EXEC) or Knob 5 (EXEC&CONT), and the initialize
confirmation display will appear. Press Knob 5 (YES) to execute
the initialize operation.
• If Knob 1 (EXEC) is used to execute the command, the display
previous to the command menu will be recalled after execution
has finished. If Knob 5 (EXEC&CONT) is used to execute the
command, the bulk dump display will be retained so you can
continue and perform further bulk dump operations.
Knob 1
Knob 2
Knob 3
Knob 4
Knob 5
Turn
—
Init Type
Program
—
InitTo
action
Press
EXEC
—
—
—
EXEC&CONT
action
About the COMMANDS
Knob 2
[
Turn] Init Type
Determines whether a single program or all programs will
be initialized.
[Range] AllPrograms, OneProgram
• AllPrograms ... Initialize all programs.
• OneProgram ... Initialize only the program
selected by Knob 3.
Knob 3
[
Turn] Program
Selects a single program to be initialized.
[Range] 001 — 128
• This parameter can only be used if Init Type is set to
OneProgram.
Knob 5
[
Turn] InitTo
Specifies the type of initialization to be performed.
[Range] RegisteredSet, FactorySet
• RegisteredSet ... The values registered via the
REGISTER command are used for initializa-
tion.
• FactorySet ... The factory preset values are used
for initialization.
[
Press] EXEC&CONT
Press this knob to call the initialize confirmation display.
Press Knob 5 (YES) to actually execute the initialize
operation.
217
Chapter 9 COMMAND
A5000/A4000 •
Advertisement
Table of Contents
