Yamaha A4000 Owner's Manual page 249

8.
Position the ZIP drive inside the A5000/A4000.
• Guide the ZIP drive into place using the groove on the side panel.
9.
Attach the ZIP drive using the same four screws removed when removing the FDD unit.
Tighten in the following order:
10.
Connect the IDE cable (40-pin) and the power cable (short) to the hard disk unit.
• Connect the longer end of the IDE cable from the central connector to the ZIP drive.
• The connectors are "keyed" so that they cannot be inserted the wrong way around.
11.
Connect the ZIP drive IDE cable (40-pin) to the connector on the A5000/A4000 circuit
board.
• Connect the other end of the flat cable from the ZIP drive (the flat, thin cable) to the corresponding con-
nector on the sampler's main circuit board (marked "C" in the illustration below, "IDE CN4" on the cir-
cuit board itself). The connector is "keyed" so that it will only go in one way.
ZIP Drive
IDE Cable
A
q w e
C
Power Cable (short)
A
ZIP Drive
Installing Optional Equipment
249
Appendix
A5000/A4000 •