Configuration On The Machine (Ipp); Configuration On The Computer - Xerox 4112 System Administration Manual

2. C on f ig u r at i on
2- 8

Configuration on the machine (IPP)

This section describes the configuration procedure to enable
Internet Printing (IPP) on the machine. First enable the IPP port,
then set the IP address.
NOTE 1: The configuration can also be performed using IP
configuration tools included in CentreWare Internet Services or
CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to "Using CentreWare Internet Services" on page 3-1.
Enter the System Administrator Mode (Chapter 1 Entering the
1.
System Administrator Mode on page 1-15.)
2. Enable the IPP port.
a. Select System Settings.
b. Select Connectivity & Network Setup.
c. Select Port Settings.
d. Select IPP and then select Change Settings.
e. Select Port Status and select Change Settings.
f. Select Enable and then select Save.
If necessary, set the IP Address (Chapter 1 Setting the IP
3.
address. on page 1-17).
Exit the System Administrator Mode (Chapter 1 Exiting the
4.
System Administrator Mode on page 1-16).
After the machine is restarted, print out the Printer Settings
5.
List to confirm that the IPP port is enabled.
Configure the IPP as necessary. Refer to "IPP" on page 3-16 for
the IPP configuration.

Configuration on the computer

See Chapter 2 Configuration on the computer on page 2-3.
Xe r o x 4112 /4 1 27 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e